Using and Maintaining the Imager
January 17, 2007 8F2927 2-7
– Select the current date and date format
– Enter the current time and select for daylight savings
– Review date/time information
• Set up film
– Unlock film drawers
– Load film
– Calibrate film
• Configure the network
– Enter the network name
– Enter the Imager IP address
– Enter the subnet mask
– Enter the gateway address
– Review the network information
• Configure the Kodak Remote Management Services
• Edit modality information/parameters
• Save/backup configuration information
• Exit the Installation Assistant
Imager Passcode
Certain operations through the touch screen require a passcode to be
entered. The Imager comes with a default passcode of 123456. This passcode
can be changed through the touch screen by selecting
Utilities>Service>Change passcode from the Main screen.
To Next Page
Loading...
