Troubleshooting
www.kodak.com/go/support
53
Light blinks green Pictures transferred to the
computer.
None required.
After transferring pictures, the transfer
light continues to blink green until
either the camera is removed, the
Transfer button is pressed again, or the
connection is no longer available.
Light is off No pictures in camera or on
memory card.
None required.
To enable Transfer:
1 Connect printer dock to computer
(page 22).
2 Take pictures.
3 Dock the camera.
Camera not docked.
Printer dock not connected to
computer.
Camera not properly seated on
connector.
Reseat the camera on the printer dock
(page 7).
Computer off. Turn on the computer.
Red-eye-reduction button/light
Light status Cause Action/solution
Light glows green Red-eye reduction applied to
pictures for current print job.
None required.
To turn red-eye reduction on
or off, press the
Red-Eye-Reduction button.
Light is off Red-eye reduction not selected.
Transfer button/light
Light status Cause Action/solution
To Next Page
Loading...
Need help?
General