Troubleshooting
www.kodak.com/go/support
47
Picture Size lights
Light status Cause Action/solution
One light glows steady
green
The indicated picture size is
available and selected.
None required.
To change picture size,
press the Picture Size
button repeatedly.
All lights are off There are no pictures in the
camera, on the card, or on the
PictBridge compatible device.
To enable the picture size
option:
1 Take pictures.
2 Dock the camera or
connect a compatible
Kodak card reader
(page 14) or PictBridge
compatible device
(page 12). If using a
card reader, make sure
a memory card is
inserted.
The camera is not docked, a
compatible Kodak card reader or
PictBridge compatible device is
not connected, or a memory
card is not inserted.
The camera is not properly
seated on the connector.
Reseat the camera on the
printer dock (page 9).
The camera, card reader, or
PictBridge compatible device is
transferring pictures to the
computer, or has established an
active connection to the
computer.
None required.
Auto-Enhance button/light
Light status Cause Action/solution
Light glows steady
green
Auto-Enhance has been applied to pictures
for the current print job.
None required.
Light is off Auto-Enhance has not been selected.
NOTE: Auto-Enhance is only available when
printing from a docked camera, the
SD/MMC card slot, or a connected Kodak
8-in-1 or Kodak 6-in-1 card reader.
None required.
To Next Page
Loading...
Need help?
General
