Troubleshooting
48 www.kodak.com/go/support
Slide Show button/light
Light status Cause Action/solution
Light glows steady
green
The Slide Show feature is available. None required.
Press the Slide
Show button to
start.
Light blinks green The Slide Show is running. None required.
To cancel the Slide
Show, press
.
Light is off The Slide Show feature is not available.
NOTE: The Slide Show feature is only available if a
camera is docked.
None required. To
run a Slide Show,
see page 21.
USB device connector light
Light status Cause Action/solution
Light blinks green Slow blink: the device is
initializing or communicating
with the printer dock.
None required.
Fast blink: there is a device or
communication error.
Check the USB connections from
the device to the printer dock
(page 15).
Disconnect then reconnect USB
cable from printer dock to device.
Light is off There is no device connected
to the USB device connector
on the printer dock.
None required.
The connection between the
printer dock and device is
loose.
Check the USB connections from
the device to the printer dock
(page 15).
A device other than a
compatible Kodak card reader
or PictBridge compatible
device is connected.
Disconnect the device. Connect a
Kodak 8-in-1 or Kodak 6-in-1 card
reader, or a PictBridge compatible
device.
To Next Page
Loading...
Need help?
General
