www.kodak.com/go/aiosupport 7
KODAK ESP Office 6100 Series All-in-One Printer
4. If the name of your network is:
5. If your network requires a password, “Enter Security String” and a keyboard
appear on the LCD. Use the LCD keyboard to enter the security string. (
See
“Using the LCD keyboard” on page 5.)
6. When the confirmation message appears, press OK.
If the printer is successfully connected, the Wi-Fi status light will be on.
If you are unable to connect your printer, go to
www.kodak.com/go/inkjetnetworking for more information.
7. If you haven’t yet installed the KODAK All-in-One Printer Software, go to
www.kodak.com/go/aiodownloads and follow the on-screen instructions to
install the software.
The printer with a wireless connection is listed as the name of the printer plus a
number (for example, KodakESP6100+1133).
Connecting to a WPS wireless router
If your router supports Wi-Fi Protected Setup (WPS), you can use WPS Connect.
WPS lets you configure your printer for a wireless network by pressing buttons or
entering a PIN.
To connect to a network using WPS:
1. Press Home.
2. Press to select Network Settings, then press OK.
3. With WiFi Setup Wizard selected, press OK.
NOTE: The Wi-Fi radio turns on automatically when you select WiFi Setup Wizard.
4. With WPS Connect selected, press OK.
Listed Not listed
Press to select your
network, then press OK.
Make sure your wireless router is turned on and
within range. If your wireless router does not
broadcast its SSID (network name):
a. Press to select Unlisted Network, then
press OK.
b. Use the LCD keyboard to enter your network
name. (
See “Using the LCD keyboard” on page 5.)
c. Select WEP or WPA/WPA2 as required for
your network's security setup, then press OK.
To Next Page
Loading...
Need help?
General
