Networking Your Printer
12 www.kodak.com/go/aiosupport
Adding a network connection to a USB-connected computer
You can change the way you connect to your printer at any time.
Changing from USB to a wireless connection
To change the printer connection type from USB to a wireless (Wi-Fi) network:
If your printer is connected to a computer with WINDOWS OS:
1. Unplug the USB cable from your printer and computer.
2. On the printer control panel, press Home.
3. Press to select Network Settings, then press OK.
4. Press to select View Network Configuration, press OK, then confirm you have
an IP address.
5. If you have not already done so, connect your printer to your wireless network.
See
Connecting to a wireless network, page 5.
6. On your computer, disable any firewall you have installed until you have
successfully completed the installation. For more information on firewalls, go to
www.kodak.com/go/inkjetnetworking.
7. Select Start > All Programs > Kodak > Kodak Printer Network Setup Utility.
• If your wireless all-in-one printer (example: Kodak ESP Office 6100+1133) is
not
listed:
a. Select No, my printer is not listed, then click Next.
b.Select your printer from the list.
c. Select Network - Wireless/WiFi, then click Next.
When your printer is detected, driver installation begins.
• If your wireless all-in-one printer (example: Kodak ESP Office 6100+1133) is
listed:
a. Highlight the all-in-one printer that is connected to your network.
b. Select Yes, my printer is listed, then click Next.
When your printer is detected, driver installation begins.
8. When driver installation is complete, click Done.
The printer with a wireless connection is listed as the name of the printer plus a
number (for example, KODAK ESP Office 6100+1133).
To Next Page
Loading...
Need help?
General
