www.kodak.com/go/aiosupport 5
2
Networking Your Printer
This section explains how to configure or change your network settings.
Connecting to a wireless network
To connect your printer to an 802.11 wireless (Wi-Fi) network, refer to the following
information.
Before you connect
You need:
• A computer equipped with a network interface card or wireless networking
support.
• A working 802.11 wireless network. Kodak recommends that you use a wireless
access point/router that uses Dynamic Host Configuration Protocol (DHCP).
• To determine whether your wireless router supports Wi-Fi Protected Setup
(WPS).
• Your network name (SSID - Service Set Identifier). You can obtain your SSID
from the wireless access point, most commonly a router, using the router’s
embedded Web server. See the manufacturer’s documentation provided with
your wireless system for more information.
IMPORTANT: The SSID is case sensitive.
• Your Wired Equivalent Privacy (WEP) key or Wi-Fi Protected Access
(WPA/WPA2) passphrase.
• To temporarily disable your firewall until the printer is successfully installed and
communicating. For information, go to www.kodak.com/go/inkjetnetworking.
Using the LCD keyboard
When you need to enter letters or numbers, a keyboard appears on the LCD.
On the printer, press , , or to select the letters and numbers, using the
correct uppercase and lowercase letters. Press OK after each character. When you
are done, select
DONE, then press OK.
• To erase a character, select BKSP (backspace), then press OK.
• To change from uppercase to lowercase, select abc/123, then press OK.
• To change from lowercase to uppercase, select ABC/123, then press OK.
• To enter punctuation or symbols, select !@#, then press OK.
To Next Page
Loading...
Need help?
General
