www.kodak.com/go/aiosupport 11
KODAK ESP Office 6100 Series All-in-One Printer
Connecting to an Ethernet network
Before you connect, you need:
• An Ethernet network that includes a router, switch, or hub with an Ethernet port.
• A Category 5 (or higher) Ethernet cable.
• To temporarily disable your firewall until the printer is successfully installed and
communicating. For information, go to www.kodak.com/go/inkjetnetworking.
To connect to an Ethernet network:
1. Connect the Ethernet cable to the Ethernet port on the back of the printer.
2. Connect the other end of the Ethernet cable to an available Ethernet port on
your router, switch, or hub.
3. If you haven’t yet installed the KODAK All-in-One Printer Software, go to
www.kodak.com/go/aiodownloads and follow the on-screen instructions to
install the software and complete your setup.
To Next Page
Loading...
