8-12 Disassembly/Reassembly TP-5606 6/02
15. Reconnect P6 to J6, P7 to J7, and P8 to J8.
16. Place the controller atop the rubber bumpers.
17. Route any external leads into the controller and
secure the ground cable to the controller chassis.
18. Install the four nuts to secure the controller to the
mounting bumpers.
19. Reconnect stator and load leads.
20. Connect 22-pin harness connector J4 to fixed
connector at rear of controller.
21. Reinstall cover on controller and secure by
tightening four screws.
To Next Page
Loading...
Need help?
General
