Kohler KD62V12 Operation And Maintenance Manual

Appendix
Standard tightening torques
Pre-tightening torque and turning angle
Fig. 114: Pre-tightening marking and angles
u Tighten mounting bolt with the specified pre-tightening torque.
u Mark the specified turning angle on the screw head and on the component 1.
Information
One edge of hexagonal screw corresponds to 60°.
u On the socket key of the torque wrench 2, mark the initial position, aligned with the marking
on the component.
u Use the torque wrench to tighten until the marking of the initial position is aligned with the
marking on the component.
u Repeat process for the other screws, according to standard or described sequence.
Information
For every maintenance task, when a sequence is specified, achieve step 1 for all the sequence
before starting step 2.
Fig. 115: Standard sequence for four, five, and six screws.
KD62V12 33521030301_8_1 EN_US 2022-09
© 2022 by Kohler Co. All rights reserved.
185

Kohler KD62V12 Specifications

General

Brand	Kohler
Model	KD62V12
Category	Engine
Language	English