Konecranes CU1 - Page 40

26.03.1996 • KHH SEENXL13A
•For Authorized KCI Service Agents Only•
KCI Hoists Corporation reserves the right to alter or amend the above information without notice
Page 40
XL
Service Manual
CU1
KCI KONECRANES GROUP
KCI HOISTS CORPORATION
Option 4; Control of brake status
Option 4; Control of brake statusOption 4; Control of brake status
Option 4; Control of brake status (> P2.13) [Password 2-413]
The new not-automatically adjusting brakes are equipped with a micro switch
monitoring the status of hoisting motor's brake i.e. it is closed/open. If the
option is activated and the micro switch is off (brake is not released i.e it is
closed but it should be open) the motor running is prevented.
This option is activated by using the password.
Option 5; Overload alarm by remote indicator
Option 5; Overload alarm by remote indicatorOption 5; Overload alarm by remote indicator
Option 5; Overload alarm by remote indicator (> P2.13) [Password 2-433]
This option changes the operation of remote indicator circuit (CU1:7-8) that
an overload alarm/warning can be given e.g. by an external horn/light. The
overload alarm is given at least for 5 sec time.
Note: This option can not be used simultaneously with Option 3.
The alarm mode is selected by the following codes:
'ol c-' constant overload
1)
alarm >110%
'ol -c' constant overload
1)
alarm >90...109% (adjustable)
'ol cb' constant overload
1)
alarm 110% and blinking
2)
warning 90...109%
'ol --' removing of overload alarm (i.e. this option)
Option 6; Overtemperature/brake wear alarm by remote indicator
Option 6; Overtemperature/brake wear alarm by remote indicatorOption 6; Overtemperature/brake wear alarm by remote indicator
Option 6; Overtemperature/brake wear alarm by remote indicator (> P2.13)
[Password 2-425]
This option changes the operation of remote indicator circuit (CU1:7-8) that
an overtemperature/brake wearing alarm/warning can be given e.g. by an
external horn/light.
Note: This option can not be used simultaneously with Option 3.
Note: This option can not be used simultaneously with Option 3.Note: This option can not be used simultaneously with Option 3.
Note: This option can not be used simultaneously with Option 3.
The alarm mode is selected by the following codes:
'ob c-' constant overtemperature
1)
/brake
1)
alarm
'ob cb' constant overtemperature
1)
/brake
1)
alarm and blinking
4)
brake
warning
'ob bb' blinking overtemperature
3)
/brake
4)
alarm and blinking
4)
brake
warning
'ob --' removing of overtemperature/brake alarm (i.e. this option)