Operation
20220505H 29
2.20 Lock function
The "LOCK" function is a safety feature included in the AP20
system when you have more than one control unit installed. It
will disable all control units except for a single, user selected
control unit location.
When the "lock" function is in use, no transfer of command may
take place; only the "active" control unit stays in command.
To enable the "lock" function, make a quick double press on the
STBY button.
P S
RUDDER
02
The display on the "active" control unit will first show a
icon
and then the icon will alternate with the mode index.
The "locked" control units in the system will show:
P S
RUDDER
02
Inactive
The “Lock function is disengaged by the following actions:
• The “active” control unit unlocks by another double press on
the STBY button.
• The system is switched OFF by any
control unit (press STBY
for 2-3 seconds).
To Next Page
