36
Measurement Modes
The measuring interval can be changed before a
sequence is started. Therefore press the mode
wheel to open the Continuous submenu.
The longest measurement interval possible is 9
seconds, the shortest 0 seconds for continous
measuring.
10.4 Basic mode
The selection options are limited to the most
essential in Basic mode. This also greatly simplifies
operation in this mode.
You can select geometry and perform calibration. In
addition, all functions in the Setup menu item are
available.
Basic mode is useful if you want to interrupt a
series of measurements and quickly perform some
other measurements in the middle without leaving
the series of measurements.
Once these other measurements are complete, you
can use
to return to the point where you interrupted the
series of measurements.
Continuous
Mainmenu
Measuringinterval
*
To Next Page
Loading...
Need help?
General
