Parameters of each mode
24
PROGRAM Select ............................................... [BROWSER]
Selects the program used by the timbre. To select the pro-
gram, use the browser that appears when you execute the
menu command “Load” or when you click the [BROWSER]
switch. (☞ “The Browser” on page 16)
You can also select the program, click the name and drag
up/down or use the up/down/left/right cursor keys of
your computer.
“IFX” (☞ “IFX” on page 22) is automatically turned on
when you select a program.
LEVEL..................................................................... [00…99]
Specifies the output level of each timbre.
PAN.......................................................... [L50…C00…R50]
Specifies the pan of each timbre.
If DRUMS is specified as the oscillator mode (☞ “OSC
MODE” on page 35) in the program used by this tim-
bre, the “PAN” field will not appear. Use the “PAN”
setting (☞p.40) in the DRUM KIT EDIT section of the
OSC page to specify the pan of each sound in the drum
kit.
OUT........................................................... [–, 1+2…15+16]
Selects the output destination of each timbre.
If DRUMS is specified as the oscillator mode (☞ “OSC
MODE” on page 35) in the program used by this timbre,
OUT AB or OUT CD can be selected as the bus to which the
output will be sent.
In the stand-alone version, nothing will be output if
you set this to other than 1+2 or 3+4.
To Next Page
Loading...
Need help?
General
