QA Full Inspection
Pa-50
3
<TEST MODE>
HOW TO ENTER TEST MODE PROGRAM
Please confirm if the connection is correct. After confirmation, install Floppy Disk and then Power ON.
After Power On, Display changes from (1) to (5) in order.
(1) (2)
(3) (4)
(5)
As soon as (5) is displayed, please press both [STYLE PLAY] SW and [DISK] SW ([STYLE PLAY]
LED ON) and keep on press them until (6) is displayed and [STYLE PLAY] LED is OFF.
After confirm (6) display and [STYLE PLAY] LED off, please release the Switches.
(6) (7)
Finally (7) is displayed, Test Mode is loaded correctly. Please press [F1] to start
To Next Page
Loading...
