Korg prologue - Programs; Program Architecture

17
Programs
Program Architecture
Aprogramincludesseingsforsounds,eects,timbres,Voicemodeandarpeggia-
tor.(MASTERknob,pitchbendwheel,OCTAVEbuons,L.F.COMP.sectionand
arpeggiatorLATCHseingsarenotincludedinaprogram.)
Try editing each related parameter, and enjoy the sounds of the prologue.
VCO 1
WAVE
OCTAVE
PITCH
SHAPE
VCO 2
WAVE
OCTAVE
PITCH
SHAPE
MODULATION
PITCH EG
PITCH EG INT
SYNC/RING
CROSS MOD DEPTH
MULTI ENGINE
NOISE/VPM/USR
OCTAVE
TYPE
SHAPE
MIXER
VCO1
VCO2
MULTI
VCF
CUTOFF
RESONANCE
EG INT
DRIVE
LOW CUT
KEYTRACK
AMP EG
ATTACK
DECAY
SUSTAIN
RELEASE
EG
ATTACK
DECAY
SUSTAIN
RELEASE
LFO
WAVE
MODE
RATE
INT
TARGET
MOD EFFECT
OFF/ON/SELECT*
SPEED*
DEPTH*
DELAY/REVERB
OFF/DELAY/REVERB*
TIME*
DEPTH*
ARPEGGIATOR
ON/LATCH*
TEMPO*
RANGE*
TYPE*
SORT
Category*
PROGRAM NAME*
TIMBRE
Sub Timbre*
Edit Timbre*
Timbre Type*
Main/Sub Balance*
Main/Sub Position*
Split Point*
PEDAL & WHEEL
M.Wheel Assign
M.Wheel Range
E.Pedal Assign
Bend Range +
Bend Range −
MODULATION
LFO Key Sync
LFO Voice Sync
EG Velocity
Amp Velocity*
OTHER SETTINGS
Multi Routing
Arpeggiator*
Voice Spread
Pan Width
Portamento Mode*
Program Level*
MULTI ENGINE
Param 1-6
EFFECTS
Chorus Type*
Ensemble Type*
Flanger Type*
Phaser Type*
User Eects Type*
Delay Type*
Reverb Type*
Mod Eect Sub Type *
Reverb/Delay Sub Type *
Mod Eect Assign*
Reverb/Delay Assign *
Basic Parametres
Detail Parametres
*: When the sub-timbre is enabled, changing these parameters will have no effect on timbres set in “EDIT TIMBRE”,
PROGRAM EDIT mode.
prologue-16