Korg prologue - Shortcuts using the SHIFT button

63
4.
Press the WRITE buon.
Thedisplaywillindicatethemessage“Areyousure?”.
5.
Turn the PROGRAM/VALUE knob to select “Yes”, and press the WRITE but-
ton.
The factory-set default data will be reloaded, and the prologue will be restored
to its factory default state.
TIP
PresstheEXITbuon,orselect“No”usingthePROGRAM/VALUEknob
andpresstheWRITEbuontocanceltheoperation.
 Neverturnotheprologuewhiledataisbeingloaded.
Shortcuts using the SHIFT button
When in Play mode,youcanholddowntheSHIFTbuonandpressotherbuons
at the same time for direct access to various convenient functions.
Function SHIFT button +
Tuning EXITbuon When the prologue’s sound generator is not
making any sound, auto-tuning occurs au-
tomatically;butyoucanusethisfunctionto
retune the prologue manually in Play mode
if the tuning seems to be drifting.
The internal temperature tends to changes
more right after the power is turned on,
which may cause the instrument to go out of
tune.
Press the EXITbuonwhileholdingdown
theSHIFTbuonagaintocancelmanual
tuning, if you accidentally started it by mis-
take.
Pitchseings PITCHknob Sets the pitch in semitones.
Eectselect OFF/ON/SELECT
switch(MODEFFECT)
Pushing this switch to SELECT allows you to
settheeect’ssub-type.
LFOwaveform
phaseseings
INTknob(LFO) This allows you to invert the phase of the
LFOwaveform.
MULTI EN-
GINE parameter
seings
SHAPEknob(MULTI
ENGINE)
Adjuststhemodulatorratiowhenseingthe
VPMwiththeMULTIENGINE’sNOISE/
VPM/USRswitch.