Korg prologue - Page 46

46
Button 3 (TIMBRE)
Thisconguresthetimbreseings.
Sub Timbre [O, On]
Sets whether the sub-timbre is enabled or disabled.
Edit Timbre [Main, Main+Sub, Sub]
This selects the timbre to edit.
Main: Edits the main timbre.
Main+Sub: Edits both the main and sub-timbres.
Sub: Edits the sub-timbre.
TIP
Editing a timbre applies to the basic parameters on the front panel, as well
asalldetailedparametersinPROGRAMEDITmode.
Timbre Type [Layer, Xfade, Split]
Sets the performance type for the main timbre and the sub-timbre.
Layer: The main timbre and sub-timbre will be layered together when playing.
Xfade:Asyoumoveupthekeyboard,thesubtimbrewillgraduallyfadeintothe
main timbre.
Split:Themaintimbreandsub-timbrewillbesplitintodierentrangesofthekey-
board when playing.
Main/Sub Balance [0...127]
Adjuststhevolumebalancebetweenthemaintimbreandthesub-timbre.
64: The volume for the main timbre and the sub-timbre will be the same.
Increasing the value will make the main timbre louder, and decreasing the value
will make the sub-timbre louder.
Main/Sub Position [Sub <--> Main / Main <--> Sub]
This sets the positions of the main timbre and the sub-timbre.
Sub <--> Main: Positions the main timbre on the right side of the keyboard, and the
sub-timbre on the left side.
Main <--> Sub: Positions the main timbre on the left side of the keyboard, and the
sub-timbre on the right side.
Split Point [C-1...9]
This sets the split point for the main and sub-timbres.