Korg prologue - Page 8

8
6.
MIDI IN/OUT connectors
TheseconnectorsallowtheprologuetoexchangeMIDImessageswithanexter-
nalMIDIdevice.Referto“UsingwithotherMIDIdevices”(p.66) for details.
7.
SYNC IN/OUT jacks
Use a stereo mini-cable to connect the prologue to the Korg volca series and
other instruments. This is used to synchronize the steps of the prologue with the
pulsessentfromtheaudiooutjackofconnecteddevices,DAWsandsoon.Refer
to“SyncingtoinstrumentswithSYNCIN/OUTjacks”(p.64) for details.
8.
OUTPUT L/MONO, R jacks
These jacks are for stereo output. Connect these jacks to a powered monitor
speakerormixer.ThevolumelevelisadjustedusingtheMASTERknob.Toout-
putmonauralsound,usetheOUTPUTL/MONOjack.
9.
(Headphone jack)
This jack outputs the same signal as that of the OUTPUT jack. Connect your
headphone plug here.
Connecting to audio devices
•
Connect your powered monitor speaker, mixer or other components to the OUT-
PUTjack(monauraloutput)oftheprologue.Adjustthevolumelevelusingthe
MASTERknob.
•
Connect your headphones to the headphones jack. This jack outputs the same sig-
nal as that of the OUTPUT jack.
Connecting to MIDI devices or a computer
•
ToexchangeMIDImessageswithanexternalMIDIdevice,connectthedeviceto
theMIDIIN/OUTconnectorsontheprologue.
•
ToexchangeMIDImessageswithyourcomputer,connectyourcomputertothe
USBBconnectorontheprologue.
TIP
Referto“UsingwithotherMIDIdevices”(p.66)fordetails.
Connecting the SYNC IN and OUT jacks
•
UsetheSYNCINandOUTjackswhenyouwanttosynchronizetheoutputpulses
andstepsfromtheSYNCIN/OUTjacksoftheKorgvolcaseriesortheaudioout
jacksofaDAW. Use a stereo mini-cable for this connection.
•
TheSYNCOUTjacksendsa5Vpulseof15msatthebeginningofeachstep.
TIP
Referto“SyncingtoinstrumentswithSYNCIN/OUTjacks”(p.64) for
details.