6
2.2
Turning
the
power
on/off
Turning on the power
1
When
all necessary connections are complete,
press
the POWER
switch
to
turn
on
the
power
of the Prophecy.
2
Turn
on
the
power
for
your
powered speakers or stereo amp.
When the Prophecy's power is turned on, the opening screen will be displayed for several seconds,
and
then the Performance
mode
page will appear.
Immediately after power-on,
you
will always
be
in this mode.
Program
ADO
(*1)
will be selected,
and
the arpeggio
pattern
that
was last selected
when
the
power
was
turned
off will be selected.
*1.
If
the Global section
page
GLB-21
Page Memory setting is
turned
ON, the
program
that
was
selected
when
the
power
was
turned off will
be
selected.
Example of the Performance mode display
.....
..
,::
....
i.'
..
''.
EG
Turning off the power
Press the POWER switch once again, and the Prophecy's
power
will go off.
Turn
off the
power
to
your
powered
speakers or stereo
amp
before turning off the Prophecy.
2.3
Adjusting
the
volume
Rotate the VOLUME knob to set
an
appropriate volume.
This knob also sets the
headphone
volume.
«Getting back into Performance mode»
VOlUME
The Prophecy allows
you
to
move
easily
between
the various
modes
and
operations
such
as
Program
Write or Demo Playback. This means that until
you
become accustomed to operating the Prophecy,
you
may
inadvertently move to some other mode or to
an
unfamiliar display.
If
you
ever need to get back to
Performance mode, use the following procedure.
If
the Performance
mode
display
shown
above does
not
appear
in the LCD, check the following points.
1.
Turn
on
the Performance (upper)
LED
for the PERFORMANCE/EDIT select key.
If
the Edit (lower)
LED is blinking, press the PERFORMANCE/EDIT Select key to make the
upper
LED
light.
VALUE
+
ENTER
EXIT
EXITkey
PERFORMANCE LED is lit
Select key
FitTER
EG
If
pressing the PERFORMANCE/EDIT Select key does
not
switch the LED,
you
have
entered
Pattern
Define
mode
or Program Write from Edit mode. Repeatedly press the
EXIT
key until the screen display
no longer changes. Then press the PERFORMANCE/EDIT Select key to make the
upper
LED light.
2.
If
the
upper
LED
of the PERFORMANCE/EDIT Select key is lit
and
the display is different
than
that
shown
above, press the
EXIT
key until the display no longer changes.
To Next Page
Loading...
