• Setting and using controllers
The Prophecy has a variety of controllers;
Wheell-3,
Ribbon Controller, Foot Pedal, Foot SW etc. For
each
program
you
can freely assign the function of each controller, to control the
sound
in the most
suitable way.
In
an
initialized program, the controllers are assigned as follows.
Wheell
Wheel2
Wheel3+
Wheel3-
RibbonX
RibbonZ
FootPedal
FootSW
Pitch
Bend+-
Control Change 1
Control Change 2
Control Change 3
Control Change 16
Control Change 17
Control Change 18
Sustain (Control Change
64)
Let's
make
some changes to these settings.
[I
Press the
COMMON
key,
and
use the PAGE keys to
move
to
page
CMN-5
[Wheel1/2
Assign]. Rotate knob 1 to modify the function assigned to
Wheell.
For this example, set
Wheel1
OFF. Move
Wheel1
and
notice
that
the Pitch Bend effect does
not
occur.
Use the PAGE keys to move to
page
CMN-7 [Ribbon Assign]. Move knob 1 to change the
Ribbon X setting to Pitch
Bend+-.
Move
your
finger
over
the Ribbon Controller to left
and
right,
and
notice
how
the
pitch
bend
effect is
applied.
Moving
from
the
center
toward
the
right
end
of the ribbon will raise the pitch,
and
moving
toward
the left will
lower the pitch.
Rotate knob 3 to
set
XVC:ON.
With
this setting, the location where
you
first place
your
finger
on
the ribbon will be the zero
point
of the controller value. Operate the ribbon
and
notice the result.
Use the PAGE keys to move to
page
CMN-6 [Wheel3 Assign]. Notice
that
the settings are
"+:007(CChg#02)"
and"
-:008(CChg#03)".
This means
that
moving the wheel
upward
will transmit control change
#2,
and
moving
it
downward
will
transmit
control
change
#3.
Let's
use
this to control the
sound.
First
press
the FILTER key,
and
use the PAGE keys to
move
to
page
FLTl-5
[Fe
Modulation].
Rotate knobs 3
and
4 to make a setting of "CChg#02:Int+20". Raise
Wheel3
upward,
and
the
cutoff frequency of Filter 1 will change. Next,
press
the MIXER key,
and
use
the
PAGE keys to
move
to
page
MIX-7
[NOISE~
OUTl]. Rotate knobs 1, 2,
and
3 to
make
settings
of
"Lvl:OO"
and
"CChg#3:Int+50".
Move
Wheel3
downward,
and
notice
that
noise is mixed into the
sound.
Try
operating
the Ribbon Controller
and
Wheel 3
at
the
same time to modify the pitch
and
tone.
The examples above
demonstrate
only a small fraction of the possibilities of the Prophecy. For details
on
its other functions, refer to the separate Parameter Guide.
29
To Next Page
Loading...
