Korg Prophecy - Performance Editor(PE); Selecting a Performance Editor; About the Performance Editor Display; Saving a Sound that was Modified by the Performance Editor

2.6 Performance Editor (PE)
Modifications to the sound of a program are done in Edit mode. However in Performance mode, you
can also assign any desired parameter ( * 1) to knobs 1-5, allowing you to adjust volume or brightness
of the sound, envelope
speed (the time over which the sound rises or decays), or effect settings. This
capability is referred to as the Performance Editor
(PE) function. Each program has four PE sets. If two
or more PE sets are turned on, one knob can modify up to 4 different parameters at once.
*
1
Parameters are assigned to the Performance Editor in Performance Editor Define (see page 32).
• Selecting a Performance Editor
When one of the PE1-4 keys are pressed to make the LED light, that Performance Editor is turned on.
The previously selected
PE will be turned off. Pressing the key of a currently-on PE will also turn it off.
If you wish to turn on two or more Performance Editors, press the desired PE keys simultaneously. PE
keys that were not pressed will be turned off. To turn off PE keys that are on, individually press the PE
keys that are on.
With a
PE turned on, rotate knob 1-5 to modify the value of the parameters assigned to them, and listen
to the tone change.
H~::~~~i:~ Pr·or::·\···p::;··\: .. ic. ~::;t;:::·F·~::. ~ ~ ;.:,j: ·:•r F~rr~: UP
tii!!!!!~!!!!!!!!!!!i::i' UZF'i·lc'd I Ci;;:,Fbk l!!!i!!i!!!!!!!!!!H!!::::il D l :!Fbk
• About the Performance Editor display
Rotate a knob, and the value will change.
PEl
EfFECT
PE3
PE-6 I
PE2
EG
lFO
If after rotating a knob you then select another program (or if you enter Define or Edit mode, rotate a
knob, and then return to Performance mode), an arrow will appear in the display as shown below. This
indicates that the physical position of the knob differs from the value memorized in the program. Rotate
the knob in the direction of the arrow until it reaches the location of the program setting,
and from that
point the knob will once again control its assigned parameter(s).
Rotate the knob to modify the level.
1!!:::::::::::::::::::::::!! li!!~!!!!!!!!!::::il
-0
Rotate the knob in the direction of the arrow. Control
will resume when the memorized value is reached.
I i!<~::::::::::::::J I !1:::::::::::::->::J
When PE1-4 are turned on, the display will show an abbreviated name for the parameters assigned to
each knob.
• Saving a sound that was modified by the Performance Editor
Changes you make to a sound in Performance mode by operating the Performance Editor can be saved.
For the Write procedure, refer to
"4.3 Saving a program" (page 30).
1 1