WHEEL 2
The effect will increase as the wheel is moved from the lowest position away from yourself. Normally this
wheel is used to adjust the depth of vibrato.
0
CChg#01
WHEEL 3 +direction
WHEEL 3
-direction
Here's how WHEEL 2 functions when the Edit
mode Common section page CMN-5 Control
Wheel 2 parameter is set to
CChg#01 . The
example
is
for when the Edit mode OSC section
page
OSC1-4 lnt.CC#1
Ctr1
parameter is set
to+.
The effects will be applied as
you
move the wheel
away
from or
toward
yourself, relative to the center
0 position.
If
separate
functions are assigned to WHEEL 3+
and
WHEEL
3-,
different effects
can
be
applied
by
moving the wheel in the +
or-
direction.
WHEEL 3 HOLD key
If
this key is pressed while WHEEL 3
is
being operated, the effect at
that
moment will be held,
and
will
continue even after WHEEL 3 returns to its original position. While Hold is
on, the LED will light. Press
the key once again to defeat the hold function. When WHEEL 3 is
at
the 0 position, press the key once
again to re-apply the effect
that
was previously held. Also,
if
WHEEL 3
returns
to the held location
while hold is still
on, hold will automatically be canceled.
While
Hold
is on,
you
can move the wheel in the other direction to
apply
both
effects simultaneously.
RIBBON (X)
The effect will be applied
when
you
move your finger to left or right on the ribbon.
•
Depending
on
the
setting of
Edit
mode
Common
section
page
CMN-7 X
Variable
Center,
this
can
be
used
in
two
ways.
OFF:
The left edge of the ribbon controller will be
0.
If
PBend+- is selected, the center will be
0.
ON:
The location where you first touch the ribbon controller will be
0.
RIBBON (Z)
The effect will be applied
when
you
press
down
on the ribbon controller.
RIBBON
(X):
The effect will be applied when you move
your finger
to
left
or
right on the ribbon controller.
If X Variable 0 Point is OFF: the left edge of the ribbon
controller
will be 0 (for PBend+-, the center will be 0).
If
X Variable 0 Point is ON: the location where you first
touch the ribbon
controller will be 0.
t
WHEEL 3 (+)direction: The effect
will be applied when you rotate the
wheel upward.
0
l
WHEEL 3
(-)
direction: The effect
will be applied when you rotate the
wheel downward.
-·-
1
WHEEL3
1)
RIBBON (Z): The effect will
be
applied
when you apply pressure.
If you move WHEEL 3 to location
·a·
and press the WHEEL 3
HOLD key, the effect at 'a' will be maintained even if you return
the wheel to the center.
Pedal volume (optional)
In
this condition if you move the wheel to 'b', the effect specified
for WHEEL 3- will be applied as well.
Pressing a pedal volume
(EXP-2,
XVP-10,
etc.) connected to the
FOOT
PEDAL
jack will apply the specified
effect.
•
The
polarity
of
the
pedal
volume
can
be
switched
in
Edit
mode
Global
section,
page
GLB-4
Foot
Pedal
Polarity.
13
To Next Page
Loading...
