Korg SQ-64

18
SQ-64 Owner's Manual
■
Parameters that can be congured in modulation mode
Operation
option
PARAM1 PARAM2 PARAM3 PARAM4
Operation by
knob
Increases/
decreases all
modulation values.
(in units of 0.5)
Rotates the
modulation
values of the
sequence. (by
step) [64<…>64]
Sets the probability
of a random
variation of the
modulation values.
[0%-100%]
Sets the
interpolation curve
of modulation CV
[NONE, LINEAR,
EXP].
While holding
down SHIFT
Increases/
decreases all the
modulation values.
(in units of 10)
Rotate the
modulation values
of the sequence.
[L64…CENTER…
R64]
Sets the range
of random
modulation value
variations. [0%-
100%]
Sets how the
modulation should
be output via MIDI
[ VELO. , CC 0, ... ,
CC 127 ]
While holding
down 64
pads
Increases/
decreases the
modulation value
for the selected
steps. (in units of
0.5)
-
Sets the probability
of a random
variation of the
modulation value
for the selected
steps. [0%-100%]
Sets the range
of random
modulation value
variations for the
selected steps. [0
to 100%]
Loop mode
Press the LOOP button to enter loop mode.
In this mode two types of loops can be created.
RANGE
Press a step to determine the start step of the loop,
then select the next step while pressing the rst step to
determine the last step of the loop. Double tap any step of
the loop to release the loop.
SELECT
Press any number of steps. The sequence will automatically
start playing only the selected steps. When any step is
released it will be removed from the loop. Double tap any
step of the loop to release the loop.
■
Parameters that can be congured in loop mode
Operation
option
PARAM1 PARAM2 PARAM3 PARAM4
Operation by
knob
Sets the loop
tempo [1/64, ..1/2,
1x, 2x..16x].
Sets the
probability that
the next step in
the loop is chosen
at random. [0-
100%]
Sets the loop
type [RANGE,
SELECT]
Sets how the
sequence should
resume when the
loop is released.
[IN-PHASE, FREE]
Control mode
Press the CONTROL button to enter control mode.
In control mode the Track button A-D, the 64 pads , and the
PARAM1-PARAM4 knobs act as dedicated MIDI controls.
The BAR button 1-4 can be used to select one of four pages of
assignments for the param knobs. To assign MIDI messages to
buttons and 64 pads, press A-13 to 16, B13 to 16, C13 to 16, and
D13 to 16 of the 64 pads to switch 16 types of control mappings
while pressing the CONTROL button in global mode.
Note The MIDI control message mapping presets can be edited using
an external editor/librarian. See "SQ-64 Editor" (www.korg.
com) for details.