1–1: Load
149
1–1h: Open button
Use this button to open a directory, and move the current directory to the next lower level.
This is available only when a directory is selected in “1–1b: Directory Window.”
1–1i: Up button
Use this button to move the current directory to the next higher level.
If the current directory is the root directory (where the current directory display is only “/”), this
button is not available.
1–1j: Drive select
Select the disk that will be used for loading and saving.
The volume label of the disk will be displayed, and disks without a volume label will be indicated
as “
no label
.”
With the standard system, only the internal floppy drive can be selected.
▼
Page Menu Command
1–1A: Hide Unknown Files (check command)
If this is
checked
, undefined file types will not appear in the directory window. However this is
valid only if the current directory is a DOS directory.
1–1B: Load Selected
This command loads the file or directory selected in “1–1d: Directory Window” into internal mem-
ory.
When this command is selected, a dialog box will appear, but the dialog box that appears will
depend on the file from which you are loading data. (Refer to “
a
” through ”
p
” below.)
1
Program
1
Combination
1 Drum Kit
All
Programs
All
Combinations
All
Drum Kits
Global
Parameters
Up KeyOpen Key
All Programs
All Combinations
All Drum Kits
Global Parameters
PCG File
a
b
c
d
e
f
g
h
i
j
SMF Data
Standard MIDI File
o
1 Bank
Programs
1 Bank
Combinations
Exclusive Data
EXL File
p
All Songs
SNG File
k
l
1 Song
m
All Tracks 1 Pattern
n
To Next Page
Loading...
Need help?
General
