Various messages
163
Not enough memory to open pattern
P
Pattern conflicts with events
Pattern is across destination end measure or source start measure
R
Root directory is full
S
Source is empty
T
There is no readable data
Track number over
U
Unable to create directory
Y
You can’t undo this operation
Situation:
When executing Save Exclusive in Disk mode, there was not enough free sequencer
memory.
Action:
Delete song data (after saving it if necessary).
Situation:
There was not enough sequencer memory to open the pattern, so it cannot be edited.
Action:
Delete unneeded song, track, or pattern data, or open the pattern.
Situation:
Bouncing was not possible, since one track contains a pattern, and the other track con-
tains an event or pattern in the same measure.
Action:
Open the pattern.
Situation:
When moving measures, a pattern has been Put in the destination end measure or the
source start measure, and editing is not possible unless the pattern is opened.
Action:
Open the pattern.
Situation:
You attempted to create a file or a directory in the root directory, but this would exceed
the number of allowable root directory entries.
Action:
Either delete an existing file or directory, or use a different disk.
Situation:
Data does not exist in the track or pattern specified as the source.
Action:
Specify a track or pattern that contains playback data.
Situation:
On a
TRINITY series
instrument which does not have the
PBS-TRI
option, you
attempted to load a file which contained only banks C and D.
Situation:
When loading a Standard MIDI File, the number of loaded tracks exceeded 16.
Situation:
You attempted to create a directory that would exceed the hierarchical limit (64 charac-
ters for the full pathname).
Situation:
In Sequencer mode, it is not possible to allocate sufficient free memory to allow you to
Undo the recording or event editing operation after it has been performed. If you wish
to preserve the previously recorded or edited data, press the
OK button
. If you wish to
return to the previous data (and delete the previously recorded or edited data), press
the
Cancel button
.
To Next Page
Loading...
Need help?
General
