4–1: Filter 1 EG
35
Alternate Modulation
Unlike the modulation settings that allow Keyboard Tracking and Velocity to affect EG times,
Alternate Modulation cannot be set independently for each EG Time (Attack/Decay/Slope/
Release Time).
AMS (Alternate Modulation Source) [OFF…Tempo]
Selects the source which will control filter 1 EG times.
With a setting of OFF, modulation will not be applied.
Intensity [–99…+99]
Refer to “2–5b: Time Modulation.”
For details on how Alternate Modulation and the other AMS functions operate, refer to page 157
“8. Appendix” in this manual and to page 33 “About alternate modulation” in the Basic Guide.
4–1c: Level Modulation
Specifies how the filter 1 EG levels set in “4–1a: Filter 1 EG” will be modified.
Velocity
With positive (+) settings, EG levels will be raised as you play more strongly. With negative (–) set-
tings, EG levels will be lowered as you play more strongly.
With a setting of 0, the EG levels specified in “4–1a: Filter 1 EG” will be used.
St (Start Level) [–99…+99]
Adjusts the Start Level.
At (Attack Level) [–99…+99]
Adjusts the Attack Level.
Br (Break Point Level) [–99…+99]
Adjusts the Break Point.
Note-off
Changes in Time (all four parameters with positive (+) settings)
Filter EG settings
Softly played note
Strongly played note
Note-on
Note-off
Note-on Note-on
Note-off
Changes in Filter 1 EG (with all four at positive (+) settings)
Settings of 4–1a: Filter 1 EG
Softly played note
Strongly played note
Note-on
Note-off
Note-on
Note-off
Note-on
Note-off
To Next Page
Loading...
Need help?
General
