1–3: Mixer (Track 1–8)
84
1–3i: Force Poly
This setting is available only for tracks which are using a program that is set to mono mode (which
plays only single notes).
If this setting is
checked
, the program will play polyphonically. (i.e., the program will temporarily
be set to polyphonic.)
Mono mode settings are made in Program Edit mode “1–1d: Assign/Hold” (
☞
page 6 in this man-
ual).
▼
Page Menu Command
1–3A: Memory Status
This command displays the remaining amount of sequencer memory.
1–3B: Delete Song
This command deletes the currently selected song. When this command is executed, the musical
data, settings, and patterns of the currently selected song will be erased, and the memory area that
had been occupied by the song will be freed.
For details refer to “1–1B: Delete Song.”
1–3C: Copy From Song
This command copies all setting data and musical data from a specified song to the currently
selected song. When this command is executed, all setting data and musical data of the current
song will be erased, and overwritten by the data of the copy source. Before executing, be sure that
you are not overwriting important data.
For details refer to “1–1C: Copy From Song.”
1–3D: Copy From Combination
This command copies the parameters from the specified combination to the setting data of the cur-
rently selected song. When this command is executed, the setting data of the currently selected
song will be erased, and overwritten by the setting data of the combination. Before executing, be
sure that you are not overwriting important data.
For details refer to “1–1D: Copy From Combination.”
To Next Page
Loading...
Need help?
General
