Kostal ENECTOR - Ending Charging Process

To Next Page

To Previous Page

Operation

1 12345678910111213141516

4.Optional: Select charging mode via KOSTAL Smart Energy Meter or optional push-

button.

- Power Mode (simple charging)

- Solar Pure Mode (solar charging)

- Solar Plus Mode (solar-optimised charging)

NOTE

The charging mode cannot be selected.

If the wallbox has been set to Lock Mode via the KOSTAL Smart Energy Meter, no other

mode can be selected via the optional push-button.

■ Wallbox can only be enabled via the KSEM.

✔ Vehicle is being charged.

Ending charging process

1.End the charging process via the electric vehicle or via the KOSTAL Smart Energy

Meter online interface.

2.Remove the charging cable from the vehicle by the plug.

NOTE

Damage to the charging cable

Tensile stress on the charging cable may result in cable breakage and other damage.

Only remove the charging cable from the electric vehicle using the plug.

3.Put on the protective cap.

4.Hang up the charging cable without kinks.

✔ Charging process completed.