28
10. Resetting the Data Collector
The PIKO Data Communicator can be reset to the settings it was supplied
with.
Procedure:
► Switch on Data Collector.
► Use a sharp object (e.g. the end of a paper clip) to press and hold the
reset button (Fig.3 (1)) until the power LED (Fig. 3 (C)) goes out.
☑ The device starts with its factory settings.
Note: Please note that all settings and the saved yield data are lost during
a reset.
11. Technical data
Data Collector
● Power supply by plug-type power supply: 5 V / max. 500 mA
● Ethernet interface: 10/100 Mbit/s
● USB interface for software updates
● Wireless interface 868 MHz
● Ingress protection: IP 20
Data Stick
● USB interface for connecting to a digital picture frame
● Power supply by USB: 5 V / max. 500 mA
● Wireless interface 868 MHz
● Ingress protection: IP 20
12. Compatible picture frames
You will fi nd a list of digital picture frames guaranteeing smooth operation
in the download area of the KOSTAL Solar Electric GmbH website (http://
www.kostal-solar-electric.com).
00_PIKO Data Communicator.indb 2800_PIKO Data Communicator.indb 28 20.02.2012 10:23:3820.02.2012 10:23:38
To Next Page
