Controlling the Display Automatically via the RS-232 Port
You can turn the display on or off automatically when an HDMI signal is present or lost via the
presence of 5V and/or clock signal on or off.
The “No Clock” trigger automatically sends a Standby (Off) command when no signal is
detected on the output, and “Clock” triggers and an Image View On (On) command when a
signal is detected.
To control the display automatically via the RS-232 port:
1. Connect the RS-232 port to the display and the HDMI port to the
RS-232-controlled display.
Figure 34: Sending Automatic Commands via RS-232 Port
2. In the Navigation pane, click Video & Audio. The Video & Audio page appears.
Figure 35: Video & Audio Page – Setting 5V Off Signal-Loss Delay Time
3. Enter the 5V powering off delay time and click Set.
To Next Page
Loading...
