FC-18 – Using the Embedded Web Pages
4. Set the remote port (by-default: TCP – 5001; UDP – 50001).
5. Select the IP Protocol mode (TCP or UDP).
6. Click Set Ethernet Port changes.
7. Send a display protocol command from a control system that is connected to the
Ethernet via the RS-232 port to the display.
Commands are sent to the display via RS-232 tunneling.
Configuring CEC Commands
FC-18 can send a CEC code upon detection of a defined trigger (e.g., on the HDMI input,
from an occupancy sensor, etc.), and turn the display on or off accordingly, using the settings
on the CEC Configuration page.
By default, all types of display on/off commands are listed and enabled.
If your display does not support CEC, you can control the display via RS-232 (see Controlling
the Display via its RS-232 Port on page 21) or the Ethernet (see Controlling the Display via
the Network (Ethernet) on page 28).
To send CEC commands to the HDMI acceptor:
1. In the Navigation pane select CEC. The CEC Configuration page appears.
Figure 74: CEC Configuration Page
2. Enable (default) or Disable CEC control.
3. Enter the CEC logical address (14, by default) and click Set.
To Next Page
Loading...
