Kramer FC-18 - FC-18 Firmware Upgrade Methods; FC-18 Upgrading via Embedded Web Pages; FC-18 Upgrading via PROG USB Port

Kramer Electronics Ltd.
FC-18 – Using the Embedded Web Pages
53
8. Click Add.
Figure 79: Button On Device Command
9. You can:
▪ Click Delete to delete the command.
▪ Click Test to test the command.
▪ Change any of the command configurations.
▪ Enable or disable the command.
10. Repeat the previous steps to add any other commands to the command list:
Figure 80: Ethernet Page – Unmute Display Command Added
The enabled command is sent to the display via the Ethernet.