Importing/Exporting Encoder/Decoder System Settings
Import or export the settings of the encoders and decoders in the system. you can
import/export Video Wall Routing, Preset, Preset Sequence, Groups, Video Wall, and
KVM/USB settings, or select a specific setting to import/export.
To import or export the system settings:
1. In the Navigation pane, Select Manager Settings. The General tab in the Manager
Settings page appears (see Figure 51).
2. In the General Settings page, select the system setting types to import or export.
▪ All – Select all the settings.
▪ Groups – Select all the settings in the Groups page (see Creating Groups
on page 37).
▪ Video Wall – Select all the video wall settings (see Creating Video Walls
on page 39) and routing video walls (see Routing to a Video Wall on page 27).
▪ KVM – Select all the KVM/USB settings (see Configuring KVM on page 42).
▪ Presets – Select all the preset settings (see Managing Presets on page 30).
▪ Sequence – Select all the preset sequence settings (see Performing a Preset
Sequence on page 31).
3. When importing, do the following (when exporting, go to the next step):
▪ Click IMPORT. An Open file appears.
▪ Select the file to import (settings.tar.gz).
▪ Click Open to import the file.
4. To export settings, click EXPORT.
The settings file is created (settings.tar.gz).
The system settings file is imported/exported.
Locating the Device
Locate the specific device in the system.
To locate the device:
1. In the Navigation pane, Select Manager Settings. The General tab in the Manager
Settings page appears (see Figure 51).
2. In the General Device Settings page, click APPLY next to Locate Device.
the located device NET and ON LEDs on the font panel flash for 60 seconds.
The device is located in the system.