Kramer TP-578H

6
TP-578H - Defining the TP-578H DGKat to HDMI Receiver
4 Defining the TP-578H DGKat to HDMI
Receiver
Figure 1 defines the front panel of the TP-578H.
Figure 1: TP-578H DGKat to HDMI Receiver Front Panel
#
Feature
Function
1
IR 3.5mm Mini Jack
Connect to the IR blaster or sensor
2
K-LINK Mode Button
Press to toggle between the active and passive data
modes, (see Section 6.4). The current data mode is
indicated by the K-LINK LED, (see K-LINK LED)
3
HDMI OUTPUT Connector
Connect to the HDMI acceptor, (see Section 5)
4
HDMI OUTPUT LED
Lights green when there is a video acceptor present, (see
Section 6.5.1)
5
AUDIO
OUT
S/PDIF Digital Audio
RCA Connector
Connect to the digital, stereo audio acceptor
6
ANALOG Audio
3.5mm Mini Jack
Connect to the unbalanced, stereo audio acceptor
7
K-LINK LED
The LED indicates the current K-LINK data mode:
 Lights green when the device is in active data mode
 Lights red when the device is in passive data mode
To toggle the K-Link data mode, press the K-Link button,
(see K-LINK Mode Button)
8
ON LED
The LED indicates the power supply status:
 Lights green when the device receives adequate power
 Flashes red/green if there is not adequate power, (see
Section 6.5.2)
9
DGKat LED
Lights green when the DGKat link to the transmitter is valid