Kramer TP-578H - Using TP Cables

TP-578H - Overview
5
5
Note: The TP-578H can supply power to PowerConnect devices but can only be
powered by PowerConnectPlus devices.
Warning:
Using a TP cable that is incorrectly wired may cause
permanent damage to the device
The TP-578H supports a range of:
 Up to 90m (295ft) at 1080i, or up to 30m (98ft) at 1080p on shielded
BC-DGKat524 cable
 Up to 90m (295ft) at 1080i, or up to 70m (230ft) at 1080p on shielded
BC-DGKat623 cable
 Up to 100m (330ft) at 1080i or up to 90m (295ft) at 1080p on shielded
BC-DGKat7a23 cable
Note: The transmission range depends on the signal resolution, the graphics card
and the display used. The distance using non-Kramer CAT 6 and CAT 7a cables
may not reach these ranges.
3.1 Using TP cables
Kramer engineers have developed special twisted pair cables to best match our
digital twisted pair products; the Kramer BC-DGKat524 (CAT 5 24 AWG), the
Kramer BC-DGKat623 (CAT 6 23 AWG), and the Kramer BC-DGKat7a23 (CAT
7a 23 AWG) cables. These specially built cables significantly outperform regular
CAT 5/CAT 6/CAT 7a cables.
Note: The TP-578H cannot work with unshielded cables.
!