Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 2
2.3 Recycling Kramer Products 3
3 Overview 4
3.1 Using TP cables 5
4 Defining the TP-578H DGKat to HDMI Receiver 6
5 Connecting the TP-578H 8
5.1 Connecting a Serial Controller to the TP-578H via RS-232 9
5.2 Connecting a Balanced/Unbalanced Stereo Audio Device 9
6 Operating the TP-578H 10
6.1 The K-Link Setup 4-way DIP-switch 10
6.2 Locking the EDID 10
6.3 Setting the Output Timeout 10
6.4 Setting the Active or Passive Data K-Link Mode 11
6.5 LED Operation 11
7 Wiring the TP RJ-45 Ethernet Connector 13
8 Technical Specifications 14
8.1 Default Communication Parameters 14
9 Default EDID 15
10 Protocol 3000 17
10.1 Kramer Protocol 3000 Syntax 17
10.2 Kramer Protocol 3000 Commands 20
Figures
Figure 1: TP-578H DGKat to HDMI Receiver Front Panel 6
Figure 2: TP-578H DGKat to HDMI Receiver Rear Panel 7
Figure 3: Connecting the TP-578H DGKat to HDMI Receiver 8
Figure 4: Balanced Stereo Audio Connection 9
Figure 5: Unbalanced Stereo Audio Output Connection 9
Figure 6: TP Pinout Wiring 13
To Next Page
Loading...
