Kramer TP-578H

TP-578H - Operating the TP-578H
11
11
6.4 Setting the Active or Passive Data K-Link Mode
Note: Data is transmitted even in the absence of video and audio signals.
The TP-578H treats RS-232 data in either of the following manners:
 Active—The data are treated as Kramer Protocol 3000 commands and are
processed by the microcontroller of the TP-578H
 Passive—The data is treated as raw data and is transmitted over the DGKat
link with no processing
To select the active or passive data mode:
 Press the K-Link mode button to toggle between the active and passive data
modes.
When the K-Link LED on the front panel lights green, the device is in the
active mode. When the K-Link LED lights red, the device is in the passive
mode.
6.5 LED Operation
The LEDs on the front panel provide status information as detailed below.
6.5.1 HDMI Output LED
HDMI Output LED Color
HDMI Signal State
Solid green
There is a video acceptor
Flashes green for a few
seconds, then lights solid
green
There is an acceptor connected but it does not
support HDCP
Off
No video acceptor connected
6.5.2 DGKat LED
DGKat LED Color
DGKat State
Solid green
Valid DGKat link with a video signal
Flashing green
There is a DGKat link but no video signal
Off
The DGKat link is not valid