Kramer TP-578H - 7 Wiring the TP RJ-45 Ethernet Connector; Figure 6: TP Pinout Wiring

TP-578H - Wiring the TP RJ-45 Ethernet Connector
13
13
7 Wiring the TP RJ-45 Ethernet Connector
Connect/solder the cable shield to the RJ-45 connector shield at both ends of the
cable.
Do not use a crossed TP cable with this product.
Using a TP cable that is incorrectly wired may cause permanent
damage to the device.
Do not use unshielded TP cables with this product.
Figure 6 defines the TP pinout using a straight pin-to-pin cable with RJ-45
connectors.
EIA /TIA 568B
Figure 6: TP Pinout Wiring
PIN
Wire Color
1
Orange / White
2
Orange
3
Green / White
4
Blue
5
Blue / White
6
Green
7
Brown / White
8
Brown
Pair 1
4 and 5
Pair 2
1 and 2
Pair 3
3 and 6
Pair 4
7 and 8
!