Kramer VW-4

Kramer Electronics Ltd.
VW-4 – Configuring VW-4
12
Connecting VW-4 Devices to the Network
Before setting the video-wall using the app, you need to connect all the VW-4 devices to the
same network as your PC and then open the app.
Set each device with a unique IP address. You can do this by connecting a device to the
App and changing its IP address (see Updating Network Settings on page 14).
To Connect the video-wall VW-4 devices (for example, a 3x2 video-wall, using two
devices):
1. Connect all the video-wall VW-4 devices to your network, making sure that each has a
unique IP address.
2. Open the app.
Figure 7: VW-4 Windows® Control Software App