Kramer VW-4 - VW-4 Firmware Update Procedure; Firmware Update Steps

Kramer Electronics Ltd.
VW-4 – Configuring VW-4
14
6. Click Connect. The device is connected, and a green indication circle appears under
Stat.
Figure 10: [Figure Caption]
7. Click OK. The app Status line indicates the number of devices selected and connected.
Video-wall devices are connected.
Updating Network Settings
Change the IP address and other Network settings via P3K commands (see Protocol 3000
Commands on page 31) or via the VW-4 App.
When changing Network settings, the device should be disconnected.