To update the Network settings:
1. Click Connection.
2. Click next to the TELNET number of a device. The Network status window opens.
Figure 11: Network Settings Window (Detail Window)
3. Change Network settings (if IP mode is set to Static).
4. Change the IP mode to static or DHCP.
5. Change Network settings as required.
6. Click Save and then Reboot.
Network settings are updated.
Configuring Device Settings
Once the devices are connected, you can configure each of the video-wall VW-4 devices via
the Settings tab.
Settings tab enables performing the following actions:
• Changing the Device ID Number on page 16.
• Updating the Firmware on page 17.
• Performing Factory Reset on page 18.
• Viewing Network Settings on page 18.
• Defining Input Settings on page 18.
• Defining Output Settings on page 20.
To Next Page
Loading...
