Defining Output Settings
Define VW-4 output settings.
To define output settings:
1. Select the Settings tab and then click Output tab.
Figure 18: [Figure Caption]
2. Define the OSD information behavior:
▪ Click Off to keep OSD (On-Screen-Display) info always off.
▪ Click On to keep OSD info always on.
▪ Click Info to show information for a few seconds only after a change is made.
3. Click next to Audio Mute to mute or unmute audio output.
4. Select Auto-sync off Disabled, Slow or Fast from the drop-down list. When not disabled,
the unit turns off its HDMI outputs (after the selected timeout period) when there is no
video on the input.
5. Set the status for each output (sink is green if a valid output is detected):
▪ View HDCP output status.
▪ Set HDCP status to: Follow In or Follow Out.
▪ Click Save per output.
Output settings are defined.
To Next Page
Loading...
