Configuring Device Layout
After setting the ID NAME and other device settings you can continue to configure the video-
wall layout.
Layout configuration applies to all the VW-4 devices that are connected to the same network,
making it very easy to configure the layout in one go. Once the layout is set, you can
disconnect the devices from the Network.
If you are able to connect only one device at a time, you need to set the layout separately for
each device.
The Layout tab enables performing the following actions:
• Defining Video-Wall Size on page 21.
• Setting Bezel Corrections on page 23.
• Viewing the DIP-Switch Setup on page 24.
Defining Video-Wall Size
Video-wall size is defined by the number of its columns and rows.
To define the wall size:
1. Select Layout tab.
Figure 19: Layout Tab
To Next Page
Loading...
