Performing Factory Reset
To perform factory reset:
1. Select the Settings tab and then click System tab.
2. Click Reset.
The device is reset to its factory default values (except for the network parameters).
Viewing Network Settings
You can change Network settings via the Connection window (see Updating Network Settings
on page 14).
To view Network settings:
1. Select the Settings tab and then click Network tab.
2. View the device Network settings.
Network settings are viewed.
Defining Input Settings
Manage the EDID and HDCP settings.
To define input settings:
1. Select the Settings tab and then click Input tab.
Figure 16: Input Settings
2. View the input signal status. Sync is green if a valid input is detected.
To Next Page
Loading...
