Kramer WP-5VH2 - Page 53

WP-5VH2 - Protocol 3000
47
47
Command - AUD-SIGNAL
Command Type - Audio
Command Name
Permission
Transparency
Set:
-
-
-
Get
AUD-SIGNAL?
End User
Public
Description
Syntax
Set:
-
-
Get:
Get audio input signal status
# AUD-SIGNAL?␠inp_id ␍
Response
~ nn@ AUD-SIGNAL␠ inp_id, status ␍␊
Parameters
Inp_id - input number (1 .. max input number)
status - 0 - OFF (no signal)
1 - ON (signal present
Response Triggers
After execution, response is sent to the com port from which the Get was received
Response is sent to all com ports if audio status state was changed on any input
Notes