Krell Industries Showcase - Page 49

Krell Showcase Processor 45
The final option on the CONFIGURE DEVICES menu is CONFIGURE TRIGGER.
This option allows you to customize the operation of the four remote
output 12 VDC (12 Volt trigger) connectors (54) on the back panel.
Select
CONFIGURE TRIGGER from the CONFIGURE DEVICES menu. The
CONFIGURE TRIGGER screen appears:
Use the direction and enter keys to select the source device, the
trigger(s) you want to configure, and the mode and delay for each
trigger you select. The delay is only available when a trigger is set
to
ENABLED. There is a three second delay after you select ENABLED,
before the trigger turns on. The trigger turns off immediately when
you select
DISABLED.
System Configuration, continued
Configure Trigger
SHOWCASE
-CONFIGURE TRIGGER-
MODE
ENABLED
 DVD 
TRIGGER 1
DELAY
N/A
Configure Trigger Screen
How To Navigate the Menu
and Make a Selection
1. Use the direction keys to scroll
from line to line.
2. Press enter to select a line.
3. Use the direction keys to scroll
through options within a line.
4. Press enter to select and set
an option.
5. Use the direction keys to scroll
to the next line.