ADD FURNACE CO.,LTD.
44 ซอยบรมราชชนนี
โทร: 02-888-3472 โทร: ออกแบบ:08-08-170-170 แฟกซ์: 02-888-3258
https://www.add-furnace.com E-mail: sales@add-furnace.com
Application
IC 40
The IC 40 offers additional functions. It can be used in con-
tinuously-controlled burners and in stage-controlled burners.
Settings on the actuator IC 40 can be made using a PC with the
parameterization software BCSoft
®
. All the relevant settings for the
process are made using the software via an optical interface.
Various operating modes, which may be modified, are stored in
the unit. In addition, the control type (two-point signal, three-
point step signal or continuous control), running times, adjustment
angles and intermediate positions can be programmed.
The actuator can also be controlled “by hand” using the soft-
ware.
Once set, all the parameters can be saved on the PC and
copied from there into other actuators, thus saving time dur-ing
the commissioning process.
Service technicians can call up statistical data using
BCSoft
®
, such as hours of operation, actuating cycles and
a faul history. Some values can also be set to zero, for
example to record data over a specific period of time.
To Next Page
Loading...
