ADD FURNACE CO.,LTD.
44 ซอยบรมราชชนนี
โทร: 02-888-3472 โทร: ออกแบบ:08-08-170-170 แฟกซ์: 02-888-3258
https://www.add-furnace.com E-mail: sales@add-furnace.com
IC 40 function
4.11 Statistics
The statistical data stored in the unit, such as fault signals
which have occurred, various counter readings and
measured values, is displayed in statistics in BCSoft
®
.
The counters and measured values ranges are each split
into overall data and customer data. The customer data
is used for recording information over a specific period.
4.11.1 Counters
Actuating cycles (0 – 100 – 0%), changes of direction
(Open/ Closed), switching of the output relays, “Power
On” switching operations and mains operating hours are
added in the sta-tistics. Besides the total counters, there
are customer counters for recording information over a
specific period.
4.11.2 Measured values
The minimum and maximum internal housing
temperatures are saved in statistics. In addition, the
current internal tempera-ture is displayed. Here as well,
there is a customer memory for viewing a period.
4.11.3 Resetting statistics
All signals and customer data can be reset. The reset
date is saved automatically and displayed together with
the customer data.
Counters and measured values cannot be reset or
deleted.
4.11.4 Resetting a signal
A fault signal is signalled by the red LED on the actuator.
The detailed cause of the signal is displayed in BCSoft
®
.
The cause must be remedied. The signal can then be
acknowledged and reset with BCSoft
®
.
61
To Next Page
Loading...
