Krone EasyCut R 280 - 1 Table of Contents

Table of Contents
3
Pos: 4 /Überschrif ten/Überschrifte n 1/F-J/Inh altsverzeichnis @ 3 1\mod_12519 69952727_78.d ocx @ 302165 @ 1 @ 1
1 Table of Contents
Pos: 5 /BA/Inhalts verzeichnis Spr achenneutr al@ 10\mod_12215 74899104_0.doc x@ 135495 @ @ 1
1 Table of Contents ...................................................................................................................................3
2 Foreword .................................................................................................................................................6
3 Introduction.............................................................................................................................................7
3.1 Purpose of Use .................................................................................................................................. 7
3.2 Validity ............................................................................................................................................... 7
3.2.1 Contact........................................................................................................................................... 7
3.3 Identification Plate ............................................................................................................................. 8
3.4 Information Required for Questions and Orders................................................................................ 8
3.5 Intended Use ..................................................................................................................................... 9
3.6 Technical data ................................................................................................................................... 9
4 Safety.....................................................................................................................................................10
4.1 Identifying Symbols in the Operating Instructions ........................................................................... 10
4.2 Identification of the hazard warnings............................................................................................... 10
4.2.1 Personnel Qualification and Training........................................................................................... 11
4.2.2 Dangers in Case of Non-compliance with the Safety Instructions............................................... 11
4.2.3 Safety-conscious work practices ................................................................................................. 11
4.3 Safety Instructions and Accident Prevention Regulations............................................................... 12
4.4 Attached devices ............................................................................................................................. 13
4.5 PTO operation ................................................................................................................................. 14
4.6 Hydraulic system ............................................................................................................................. 15
4.7 Maintenance .................................................................................................................................... 15
4.8 Unauthorised Conversion/Modification and Spare Parts Production .............................................. 16
4.9 Inadmissible Modes of Operation.................................................................................................... 16
4.10 Working in the vicinity of power transmission lines ......................................................................... 16
4.11 Introduction ...................................................................................................................................... 17
4.12 Position of the Adhesive Safety Stickers on the Machine ............................................................... 18
4.12.1 Re-Ordering the Adhesive Safety and Information Labels...................................................... 20
4.12.2 Affixing the Adhesive Safety and Information Labels .............................................................. 20
5 Commissioning.....................................................................................................................................21
5.1 First installation................................................................................................................................ 21
5.2 Special Safety Instructions .............................................................................................................. 21
5.3 Mounting onto the Tractor................................................................................................................ 22
5.3.1 Clutching points ........................................................................................................................... 22
5.4 PTO shaft......................................................................................................................................... 23
5.4.1 Length adjustment ....................................................................................................................... 23
6 Start-up..................................................................................................................................................25
6.1 Mounting onto the Tractor................................................................................................................ 25
6.2 Hydraulics ........................................................................................................................................ 27
6.2.1 Special Safety Instructions .......................................................................................................... 27
6.2.2 Connecting the hydraulic lines..................................................................................................... 27
6.3 PTO shaft......................................................................................................................................... 29
6.4 Install the PTO shaft ........................................................................................................................ 30
6.5 Intermediate PTO shaft.................................................................................................................... 30
6.6 Swivelling parking support into transport position ........................................................................... 31
6.6.1 Four supports (optional)............................................................................................................... 31